BONA REFRESHER INSTRUCTIONS

NOTE: Applying Refresher to a satin or low gloss surface will increase the gloss level so always do a test section first.

Bona wood refresher is a ready to use waterborne maintenance coating for finished wood flooring.  It revives a scratched and dull surface giving a newly finished look and continued protection against wear.

1.       Remove loose dirt and grit from your floor.  Clean thoroughly with Bona Wood Floor Cleaner.  Repeat to ensure that dirt will not be trapped in the coating.  Make sure the floor is completely dry before applying refresher.
2.       Shake container several times before opening.  Apply refresher with the applicator pad. Prepare the applicator pad by slightly dampening it with water.  Apply Refresher in a 3-4cm wide wavy line on the floor.  Work on a small section at a time, about 3m2.
3.       Spread refresher over entire section making sure all wood is covered.  The refresher should be applied at 30-50m2 per litre.  For best results, apply a thin consistent coat.  Keep airborne dust and airflow to a minimum while floor is wet.
4.       Smooth out refresher, going with the grain of the wood.  Continue the process until the entire floor is coated.  Allow to dry a minimum of 2 hours before walking on coated floors.  If needed, a second coat may be applied after this time.  Always coat the entire floor  to ensure an even appearance and sheen.

AVOID HEAVY TRAFFIC AND REPLACEMENT OF FURNITURE AND RUGS FOR 14 HOURS AFTER THE FINAL COAT.