Parquet Panel Wood Designs

PRODUCT(S) FOUND: 27

If we don’t have it we can make it for you, subject to minimum quantities OF 500 m2

Parquet panels are engineered with a 4mm top layer and are square and normally have a border like the traditional French Versailles panel. We can make any size from 450mm x 450mm up to 1000mm x 1000mm. The finish is always oil and made with a small micro bevel.

Unfinished parquet panels can be made with square edges so that after installation they will have a light sand and then oiled for protection. This means there will be no bevels anywhere. You cannot have pre-finished panels with square edges because any damage during installation will show and spoil the dramatic effect these panels have on a floor.

Micro Bevel Edges: We can make the surface of the panel smooth and flush with each piece fitting together perfectly as they are cut by laser. The outer edge border however would have a micro bevel to protect the edges of prefinished panels during installation.

Micro Bevelled Surface: if required we can make each individual piece with a micro bevel like the Chantilly panel below which then makes it appear antique like the old solid ones.

Installing Parquet panels: You should never cut a square panel to fit a room. Always measure the room and then we can make a pale they will go near the edges and supply a border around and underneath the skirting boards. You can see examples of the Chantilly and a border around a square panel below.

Please call our team on 01666 504105 for more information.

Close Icon